Home › Knowledge Library › Food Processing in Coatings
Food Processing in Coatings
In Food Processing, equipment availability converts directly into cost. Coatings look like a small line in that budget, yet the wrong choice is one of the most common causes of unplanned downtime. This page sets out where this product group is used in the sector and which criteria decide the selection.
Why it matters in this sector
Industrial coatings are applied to cut friction, prevent sticking or protect against corrosion. PTFE-based and dry film lubricant coatings give a permanent answer on surfaces where wet lubrication is impossible or unwanted.
The result depends largely on surface preparation: cleanliness, profile and cure temperature set the life of the coating. Where food contact is involved, the relevant compliance documentation is required.
Selection criteria
- The equipment builder's approval list and minimum performance level
- Operating temperature range and ambient conditions (humidity, salt air, dust)
- Whether the viscosity grade suits the load and speed profile
- Balance between drain interval and total cost of ownership
- Packaging type and how it fits the plant's internal transfer set-up
Supply and technical support
Once an order is confirmed the goods are prepared at the Gemlik warehouse and dispatched to the requested address or to the vessel or plant delivery point. For port deliveries we handle agency coordination, paperwork and delivery timing.
Price and availability
Contact us for current pricing, stock availability and delivery times for this product group.
Request a quotation